[6-PACK] S.T. Japan Bath Pipe Sterilizing Cleaning Liquid 350g

Description:Since it is a liquid type, it quickly penetrates dirt and cleans the hot water and slime hidden inside the flow kettle and pipes. The sterilizing effect removes germs and makes it clean.

Use Method:
����In the case of one hole (forced circulation kettle)��Above the hole of the flow kettle, store water up to about 5 cm. Remaining hot water can be used. �� When applying hot water by automatic operation, set it to the minimum temperature. �� Do not remove the filter of the bathtub. The entire amount of the drug is placed near the filter of the bathtub. If you float the container, it will be a sign that it is being washed. In order to circulate the drug, operate the recooking operation for 2~3 minutes and leave for about 10 minutes. �� If you are using it for the first time or it is very dirty, it is effective to leave it for about 30 minutes. After draining, accumulate water up to about 5 cm above the hole in the flow kettle, operate the recooking operation for about 5 minutes, and drain again. �� Do not remove the filter of the bathtub.

����In the case of two holes (natural circulation kettle)��Store water up to about 5 cm above the upper hole of the flow kettle. Remaining hot water can be used. �� Remove the hot water stop cover if there is one above and below. �� Do not use leftover hot water containing bath salts. Align the mouth of the container with the lower hole and press the center to pump the entire amount of drug. If you float the container, it will be a sign that it is being washed. Leave for about 10 minutes after letting go for 2~3 minutes. �� If you are using it for the first time or it is very dirty, it is effective to leave it for about 30 minutes. While storing hot water, align the mouth of the container with the bottom hole, press the center to pump water, or pour water vigorously with a hose to remove the dirt inside and drain it. ����In the case of a whirlpool bath��Store water up to about 10 cm above the injection port. Remaining hot water can be used. The entire amount of the drug is placed near the filter. If you float the container, it will be a sign that it is being washed. Operate in standard mode for 1~2 minutes. -Stop when bubbles are about to overflow depending on the model. Leave for about 10 minutes. �� If you are using it for the first time or it is very dirty, it is effective to leave it for about 30 minutes. After draining, let the water flow to about 10 cm above the injection port and run for about 5 minutes. Then drain again.

�� In the case of a 24-hour bath / heat pump water heater�� The usage method differs depending on the model, so please refer to the instruction manual or contact the manufacturer.

Caution:
Use the full volume (350g) in a standard size bathtub (about 300L).
�� If the filter of the bathtub becomes clogged with hair or hot water stains, the water heating function may not work properly. Remove it, remove the dust with a brush, rinse it, and install it back in. -The name of the reheating operation varies depending on the model. Check the function buttons before using them. "Was there it?", "I understand", etc. �� Regular use is recommended every 1~2 months. * If you use it for the first time or if it is very dirty, you may not be able to remove the dirt.